www.sandberg.world
Quick guide
421-21
Car Jumpstarter
TirePump 10000
Quick guide
Product overview
2
5
7
8
2
4
3
1
6
12
11
10
9
1. Power On/Off
2. Mode
3. + PSI
4. Pump
5. Unit BAR/PSI/KPA
6. Light
7. – PSI
8. Display
9. USB-C In
10. USB-A Out
11. Hose Socket
12. Jumpstart port
13. Clamp Indicator Light
14. Clamp –
15. Clamp +
13
14
15
16
17 16. Jumpstart plug
17. Boost Button
1. Battery level percentage /
Pumping value display
2. Error indicator*
3. USB-A discharging
4. USB-C charging
5. Inflation unit
6. Inflation mode
7. Battery charge status
6
5
4
3
7
1
2
For air mattresses, inflatable toys, balloons etc.
Valve converter
For sports balls (footballs, basket balls etc.)
Charge Powerbank
Quick guide
3
USB-AUSB-C
Charge devices Check battery status
Error indicator*
USB discharge over current Turn off the output and wait for the fault to be cleared
- Reinsert to restore
Error message
on screen Cause Error solution
USB discharge short circuit Turn off the output and wait for the fault to be cleared
- Reinsert to restore
Sensor not detected The air pump is running and the air pressure value is
always displayed as 0
Take a 10 minute break before re-inflating
High temperature protection for inflating
Charge and discharge high temperature protection
Alarm disappears when temperature is decreased (charging temperature: 0 - 50°C, discharging temperature: -20 - 60°C)
USB-C
USB-A
Quick guide
4
1. Power on
Jumpstart Instructions
• Max: Petrol 4.0T / Diesel 3.0T • Wait 1 minute between attempts • Stop after 3 failed attempts
2. Plug in jump cable
6. Done
3. RED to (+), BLACK to (–)
4. Start engine
5. Remove cable
Go to 4
Go to 4
3 seconds
Press
Quick guide
5
Clamp Indicator Guide
X1
+ =
+ =
1 minute
Wait
+ =
Wait
+ =
Stop
+ =
>16V
Ready – You can start the engine
Too hot / timeout – Wait 1 minute and try again
Start timeout reached – Wait before retry
Wrong connection – RED and BLACK clamps are reversed
High voltage – Stop immediately and check battery type
Quick guide
6
Inflate a Tire
1.
Air hose
5. 26-51 PSI, 1.8-3.5 BAR, 180-350 KPA
Inflation modes Pressure range
26-44 PSI, 1.8-3.0 BAR, 180-300 KPA
4-16 PSI, 0.27-1.1 BAR, 25-110 KPA
30-65 PSI, 2.0-4.0 BAR, 210-450 KPA
0-150 PSI, 0-10.3 BAR, 20-999 KPA
4.
2. 3.
6.
3 seconds
to start
Press 7. Short
press to off
Flashlight procedure
Quick guide
7
3 seconds
Press
Tap 1×
Tap 2×
Tap 3×
Tap 4×
Warranty
There is a five-year warranty on your Sandberg product.
Please read the warranty terms and register your new Sandberg product at https://www.sandberg.world/warranty
helpdesk.sandberg.world
Helpdesk
Years
Warranty
For information on handling electronic waste, see https://www.sandberg.world/weee
8
NOTE: If not used regularly, please recharge the powerbank at least every 3 months to maintain optimal performance.
Car Jumpstarter TirePump 10000
Item no. 421-21
Made in China
Capacity: 10000 mAh / 37 Wh
Battery type: Lithium-ion
USB-C input: 5V/2A, 9V/2A, 12V/1.5A
USB-A output: 5V/2.4A
Clamp rated output: 12V DC 400A
Clamp peak output: 12V DC 800A
Air compressor pressure: Up to 150 PSI
LED light power: 2W
Product weight: 784g
www.sandberg.world [email protected]
Sandberg A/S
Bregneroedvej 133D, 3460 Birkeroed, Denmark